CD KP Operating terminals for Thyristor Units
- N°2 Display
- 48×96 Front Panel
- Re-Transmission
- Thyristor Configuration Port
- For CD3000M, CD3200, CD3000E and MULTIDRIVE
- Control data can be accessed locally or remotely without need to open cabinet
Dual 4 digit LED display - Scroll selection of setpoint power, power read out, current and voltage values
- Display indication for heater break alarm or SCR short circuit
- Acts as an interface communicating with up to 10 individual thyristors
- Third single digit display that indicates the address number of the thyristor
- Re-transmission of power PV, current or voltage parameters
- Re-transmission signal 4-20mA or 0-10V DC
Name | Size | Date |
---|
Manual CD-KP remote Key Pad for 3000M / 3200 Series (english) The CD-KP is designed to be connected with all CD Automation's Thyristor units via RS485 communication. On front unit is possible to read the principal operational parameters of the unit like: |
589.0 KiB 15 January 2016![]() |
Manual CD-KP Remote Keypad for MULTIDRIVE & CD3000E (english) CD-KP is a panel device allowing to display some operative parameters of thyristor units as voltage, current, power, reference, alarms, etc. CD-KP can be configured to select which parameter to display and is possible to execute commands as start and stop of the connected unit, display and reset of alarms, to change reference and ramp. All the menus (except the operator menu) can be protected by password to avoid accidental change of configuration parameters by unauthorised personnel. CD-KP has an isolated analog output 0÷10V/0÷20mA/4÷20mA to retransmit parameters’ |
1.1 MiB 15 January 2016![]() |
Datasheet CD Automation Key Pad For Thyristor Unit or CD-NEXT The CD-KP is designed to be connected with all CD Automation’s Thyristor units or CD-NEXT via RS485 communication. On front unit is possible to read in engineering units: Power, Voltage or Current. One of these variables can be selected and retransmitted via an isolated output (4 20mA or 0÷10V). On front unit is also available a plug connector for RS485 thus connecting a portable PC is possible to configure the thyristor unit or CD-NEXT without to stop the process opening the door of the cubicle. In addition is possible to diagnostic faults. |
1.0 MiB 4 June 2014![]() |